Straight Attaching Buckle – For Kencote

Weight: 0.05LB | Item# SCKW

The Straight Attaching Buckle is the easiest and quickest method for terminating non-electrified Kencote Coated Wire WTW on buildings, dimensional lumber, square posts, or other flat surfaces. No stripping or crimping required. These double-coated buckles are hot-dip galvanized and then powder coated. 

To terminate Kencote with Straight Attaching Buckle: 

• Push coated wire into hole closest to post and past buckle about 12"

• Bend 12" tail in half back against itself

• Put end of coated wire into hole at tip of buckle

• Pull coated wire up to bend

• Bend tail of wire into saddle of buckle