Subtotal $0.00
Resources
Fixed Knot Woven Wire Installation Photos
![]() |
Augering post holes |
![]() |
Measuring correct post depth |
![]() |
Using a Tamp to tamp (compact) all dirt around the post. Put in a little at a time. |
![]() |
Installing brace pin into the horizontal brace post. |
![]() |
Stringing brace wire into a figure 8. |
![]() |
Showing finished brace wire with tensioner. |
![]() |
Tool used to tighten tensioner. |
![]() |
Staples being installed to hold the woven wire in place. |
![]() |
Tying off ends on the woven wire. |
![]() |
Installing the wedges in slots to hold wire when stretching. |
![]() |
Driving the wedges to hold the wire tight. |
![]() |
Crimping sleeves are used to splice in the middle of a run. |
![]() |
Chain walkers are used with the clamp to stretch the wire. |
![]() |
Wire is being pulled up. |
![]() |
Wire is now pulled up and ready to finish. |
![]() |
Wire is being pulled to tighten. |
![]() |
Putting the finish touch of tension on the wire. |
![]() |
Staples are placed to fasten the woven wire to the post. |